Hi, I tried to create an arch. First, I drew a ring with a radius of 50 mm. Next, I duplicated this ring and changed the radius to 25 mm. Both of these rings share the same center point. Screen1. Screen2
Then, I adjusted the Start (255°) and End (285°) points. Screen3
However, as you can see, the left bottom side Screen7 of the created arch is not symmetrical to the right bottom Screen8 side. Do you have any idea why this is happening?
Beginners' Questions Why Ring is not symetric after Division in Ikskape
Inkscape.org
Hi, I tried to create an arch. First, I drew a ring with a radius of 50 mm. Next, I duplicated this ring and changed the radius to 25 mm. Both of these rings share the same center point. Screen1. Screen2
Then, I adjusted the Start (255°) and End (285°) points. Screen3
I selected both rings Sreen4 and used the Division Screen5 tool. Screen6
However, as you can see, the left bottom side Screen7 of the created arch is not symmetrical to the right bottom Screen8 side. Do you have any idea why this is happening?
Try this please:
Or easier: set up you circle to Arc: 75x75mm, Start:255, End:285 - stroke width: 25 - done (or additional Path->Object to Path if a shape is needed)