Inkscape.org
Using Inkscape with Cutters/Plotters SVG to NGC Process using Inkscape Extension
  1. #1
    FUBAR FUBAR @FUBAR

    I have tried everything including step by step videos on Youtube to get an NGC file out of the SVG.

    When I get a clean save its Zero K Inevitably it always tells me that I have not selected one of two orientation points, but when I go to that part of the menu, it does not allow me to select one.

    I have an engraver , the small 1310 model. I have Windows Home and am using the 32 bit Inkscape. 

    I have tried the 64 newer and older versions, so I am now working down the list of 32 bit

    I seem to get about as far as 99% of the videos that tell you how to do this but when I set my save path and then move off preferences. and hit the apply button it gives me the orientation point conflict message and there is Zero K in the file 

    I have the cut/engrave pattern super-imposed over the graphic, and the graphic was created on Inkscape and periodically saved during the process.

    I have amended the tool name and changed the paramaters as seen on the videos but, I still get ZeroK in the saved ngc file

    So just before hitting the save, the enclosed picture is what I have on my desktop. Any help would be appreciated.

    2022 10 23 122016
  2. #2
    FUBAR FUBAR @FUBAR

    Solved-Using Inkscape and ABViewer and everything working great. 

Inkscape Inkscape.org Inkscape Forum Using Inkscape with Cutters/Plotters SVG to NGC Process using Inkscape Extension