Inkscape.org
Using Inkscape with Cutters/Plotters Cricut for cutting tiny rectangles on vellum?
  1. #1
    Nikki.Smith Nikki.Smith @Nikki.Smith
    *

    I wrote an Inkscape extension for laser cutters (to help with prototyping electronics) but could it also work with a Cricut-type bladed cutter?

    Attached is a small test SVG. Could someone with a Cricut please try it out on 200gsm vellum (or 0.1mm vinyl) and post a photo of the results? I'm guessing that the larger squares will work ok, but the really tiny ones in the bottom right corner will be too small even with a fine blade? But that still would be good enough for some types of electronics.

    Many thanks!

    New extension for PCB solder paste stencils

     

  2. #2
    COD COD @COD

    If I am not mistaken - Cricut uses inch or centimeters. 

  3. #3
    COD COD @COD

    I just tested this attachment to do a scaling test in Cricut
    Uses CM but set the document scale to 1 px per user unit. 

  4. #4
    Nikki.Smith Nikki.Smith @Nikki.Smith

    Did anyone try cutting it? Thanks!

تجيل الدخول الآن
Inkscape Inkscape.org Inkscape Forum Using Inkscape with Cutters/Plotters Cricut for cutting tiny rectangles on vellum?

Forums developed by Martin, Jabier, Mihaela. Contact Us if you have a problem using the forum.